There are many floating adjustment methods for Taiwan fishing. In fact, what is more interesting is the floating adjustment method without hook. If you are not proficient in other floating adjustment methods, you will be confused when facing the floating adjustment method without hook. I will certainly wonder what this drift adjustment method is doing. Why cut off the hook? When you understand this drift adjustment method, you will find that although this method wastes a pair of sub-lines, it is completely acceptable because it is very suitable for wild fishing. Recently, some fishing friends asked about the drift adjustment method without hook, so here again I would like to explain this drift adjustment method, hoping that all fishing friends can understand it.
First, the advantages of no hook bleaching
The reason why non-hook drift adjustment is suitable for wild fishing is that this drift adjustment method ignores the bait weight and hook weight, and how to adjust the double bait is to the end. Moreover, it is not necessary to readjust the fishing eye to replace the bait with different weights, because the fishing eye will not change according to the change of bait weight. These two points have great advantages in wild fishing. We usually have double baits in the bottom of wild fishing, which is more suitable for bottom fishing. In wild fishing, bait change often occurs, even one kind of bait is sometimes large and sometimes small. The common drift adjustment method will change when hanging different bait weights, and the state of double baits at the bottom will change. However, this problem will not occur at all without hook drift adjustment. We have said before that it is unreliable to adjust the drift without considering the bait weight, while it is reliable to ignore the bait weight and hook weight. It is because we know the influence of the fishing purpose of the bait weight and hook weight, so let this variable not affect the drift adjustment. This method is certainly reliable. In addition to no hook and no sub-line bleaching, this state of lead falling to the bottom also ignores the bait weight and hook weight.
Second, the principle of bleaching without hook
Why are there so many advantages? This requires the principle of floating without hook. Floating without hook can be understood as floating without the pulling force of bait and hook, the weight of lead pendant, the weight of waterline and the weight of sub-line (two sub-lines without hook). The three are balanced, so no matter how much bait is used, the fishing eye will not change. Even on the float, the fishing eye will not change, just the sub-line is more curved and the lead drop is closer to the bottom. This is the principle and essence of hook-free bleaching. (When pulling up the float, the state is the same as the above picture. The fishing eye will not change, only the sub-line is more curved. If the fishing eye increases, the lead pendant will definitely come to the end. As long as the lead pendant is suspended, the fishing eye will not change)
Third, the method of bleaching without hook
1. It is not much different from other drift adjustment methods. It is better to find the bottom roughly and then pull down the float to determine a semi-water depth close to the water depth and start drift adjustment. The fishing mesh without ditch drift adjustment is to remove the mesh number of fishhooks, so the mesh number of fishhooks should not be too high, otherwise the fishing mesh height cannot see the drift clearly. Therefore, it is usually to level the water. If you use very light fishhooks such as sleeve hooks, it is also possible to adjust 1 or 2 mesh. If the hook is heavier, it is better to level the water. See the following figure:
2. After adjusting the level water, cut off the 2 fishhooks. Look at the number of mesh at this time, such as the figure below. After cutting off the 2 fishhooks, it is 2 mesh. At this time, it is the balance relationship between lead pendant, sub-line, main line and float. Reaching this fishing goal means that the weight of fishhook and bait is offset by the supporting force at the bottom of the water and will not produce pulling force on float.
Then it is to hang up a new sub-line, hang double bait and start to find the bottom. The fishing mesh reaches the mesh number when there is no hook, which is OK. The double bait must be the bottom when reaching this mesh number, and the fishhook will not leave the bottom due to the atomization of the bait, so it is very useful when fishing at the bottom. Therefore, this method can be used to catch crucian carp with earthworms in autumn, and it is also very useful to use flour bait to catch carp at the bottom. Note that the drift adjustment factor for carp fishing is that the hook will not leave the bottom due to the atomization of bait. Please collect and pay attention to it if you like, and update it on time every day. Thank you for your fishing friends!