[Fishing Skills] Fishing into the pit for so long, why am I still in the Air Force?

I believe many fishing friends into the pit fish and buy all kinds of fishing gear and equipment, but it is still difficult to leave the air force.Although II can explode the protection, but most of the time I get very little. I have also studied a lot of fishing knowledge, but I have not achieved any results.This kind of state is very painful, because, there is no problem with the adjustment and drifting, the matching of the line groups is no problem, the bait state is also OK, and even all kinds of fishing postures such as the old man’s cart devil carrying the gun are in place… is it really that there is no fish in the water?

At this time, you may have to change your thinking habits.There are too many fishermen. The first thing they do when they go to the water’s edge is to choose a good position where they think there is fish, and then lower the pole. One fishing is for most of the day or the whole day.Not many people will consciously explore the underwater situation before going down the pole, what is the overall terrain of the underwater, the depth of each place is how, etc. If these are not clearly understood, in fact, fishing is more like a gamble.Luck, choose a good position, may crazy pull;Bad luck, choose a dead, doomed air force.
Therefore, we must explore the bottom before lowering the pole. Don’t be afraid of trouble. There are two aspects to explore the bottom. One is whether the bottom of the selected fishing point is flat and there are fish in the flat place. If the slope of the bottom of the fishing point is too large, there will be no fish to stay, and the nest material will tumble down at the bottom of the water and cannot be retained. Moreover, if the pole cannot be thrown at the same position every time, the number of mesh exposed by the float will vary greatly. The second is to explore the overall topography of the water area and know which bank of water is the deepest and which bank of water is the shallowest. Then, according to seasonal weather and other conditions, deep water or shallow water is selected for fishing so as not to be uncertain.

In the process of fishing, one must also be diligent in adapting to changes. Many people start fishing after adjusting the drift. Until the end, they will not adjust the drift again. But in fact, the fish situation is constantly changing, and floating has to be adjusted accordingly. Sometimes, even if the fish’s situation remains unchanged, drift must be corrected consciously. The typical is floating draft. Most floats will have draft more or less if they soak in the water for a long time. For example, at the beginning, it was adjusted to 4 mesh and caught 2 mesh. After a period of time, the floating draft may actually become adjusted to 2 mesh. The fishing is still 2 mesh, which will definitely have an impact.
Even if the float does not draw water, there may be dirt on the float when fishing last time. If it is soaked in water for a period of time and washed clean, the eye adjustment will also change. Or the float itself is clean, and after fishing for a period of time, the dirt in the water will stick to it, which will also affect the eye adjustment. In addition, at the beginning of fishing, there was air in the lead seat, both ends were blocked by space beans, and the air could not get out of the lead seat. The lead seat had more buoyancy in the water, which also affected the floating mesh during floating adjustment. After the floating seat was soaked in the water for a period of time, the air was replaced by water, which would also produce corresponding changes to the floating mesh.
What if all the above has been done, or if there are no fish interested? Of course, we can’t keep it hard!

There are two kinds of situations when there is no fish to eat.
First, there are no fish in the nest itself. You can see if there are bubbles from fish on the water surface, or how well the fishing friends around you are fishing. If there are no fish in the nest, move as soon as possible.
Second, there are bubbles spit out by fish in the water, but the fish just don’t bite the hook, which is a bit complicated. The following is a list of the reasons for this. You can refer to it for reference.
1. The line is too thick and the hook is too big for fish to bite the hook. How to deal with it: Try changing the small hook and thin line.
2. The bait is too weak or atomized too fast. After the end, there is no bait on the hook and the fish has nothing to come out. Countermeasures: Change the bait state and increase the hook holding.
3. The taste type of bait is too strong or too light. Too strong taste type will lead to fish mania or vigilance not to eat hooks. The taste type is too light and the fish is not interested. Countermeasures: Change the flavor type of bait, change the flavor type to lighter if it is strong, and change the flavor type to thicker if it is weak.
4. The float is blunt. If the fish mouth is light, it cannot be reflected. How to deal with it: adjust the floating spirit.
5. There is mud or sauce bottom in the water, and the bait sinks in. The fish can only smell the smell and cannot find the bait. Countermeasures: Reduce the proportion of bait or increase the floating mesh so that the bait can float on the mud or sauce bottom.
6. Weather causes fish not to open their mouths. How to deal with it: Change the fishing method and try to catch off the bottom, or float, or fly lead, etc. There is really no way out and we can only go home.
Having said so much, I don’t know if there are eggs. I hope I can share some experience with you. Fishing itself is an activity with many uncertain factors. We can only try our best to reduce its uncertainty.